Swing n Slide

Parts to Assemble

Swings

Swing Hangers

Ductile heavy duty swing

Toddler swing seats

Plastisol coated swing chain

Measuring tape

Trapeze bar

Basic commercial belt

Round trapeze ring

Galvanizes Ductile Iron pipe beam swing

Quick link

Poly Handle

Super straight or wave side

Installation Safety

Consult the assembly instructions supplied with your particular model.

• Made certain slide is placed so that it is not in direct contact with sunlight.
• Check the nut, bolts, quick links, seat and swing chain are fixed properly.
• Verified the suspended climb rope on both side are fixed properly.
• Made sure not to allow children before it is properly installed.
• Accessory used are made only for swing and slide approved designs.
• Place the equipment on the level-ground.
• Determined that climbing rope or chains cannot be looped back upon itself.
• Not to attach other design apart from approved design parts.


• Safety Advisors

• Never run behind or before someone is swinging.
• Sit in the centre of the swing seat maintain the proper balance.
• Don’t play on the swing seat or slide if it is wet.
• Allow sufficient space before placing the swing in room.
• Eliminate the risk of strangulation and do not twist the chain.
• Check all the tools are in good condition and fixed properly to avoid the injuries.
• Toddler should not play alone on swing.
• Do not push fast without the seat belt.
• High age kids should not play as they have extra weight.
• Place some green grass or soft carpet beneath.
• Be sure to down with feet first from the slide.
• Check the dress of the children, it should not be over-weight.
• Determine per planned one child should be seated at one time.
• Check that on-site adult supervision must be there.
• Not to get off from the equipment while it is not in motion.

Safety Maintenance

       Put oil monthly or within 15 days in all metal parts for better result.
• Check all the nuts, bolts and swing during the usage season for tightens and                                            tightness as required.
• Rake and check the depth of the loose fills as protective surface material to

To prevent the deterioration of materials avoid plastic tools and plastics.

• Check all the sharp edges hardware during usage season.

• Paint the rusted metal parts with non-lead based paints.

• Check the swing seats, ropes, handlers, fixed arm, quick link, poly handle to assure the swing of         the swing n slide do not get disturbed.

• To prevent the deterioration later do not place the plastic seat in replacement.

Disposal Instruction  

Once the set is out it must be attached and fixed properly with all the spare parts and when the product is taken out of the service it must be disassembled and disposed off in such a way that no unreasonable hazard exists at the time when the whole set is discarded.

To anchor the unit to the ground

Use a 2” x 4” x 18” (51mm x 102mm x 457mm) pressure treated stakes. 

Pound stakes into ground at least 12” (305mm) at all inside corners of the posts.

Attach with four (4) 16d galvanized nails or 2-1/2” galvanized screws per stake into each post/A-frame.  If the unit has a climbing rope;• o Anchor the rope end.

Once the unit is completely assembled and before children are allowed to play on it, proper shock-absorbing surfacing material must be installed. 

This may be accomplished by using loose-fill materials at a sufficient depth. 

Important note

All kits must be anchored to the ground and if the unit has a climbing rope, the rope must be anchored to the ground. Cementing to the ground is necessary.